Panasonic RM-710 Bedienungsanleitung Seite 7

@ Graphic equalizer tone control knob
[5-band graphic equalizer]
This enables control of the frequency response at the
following 5 points: 60 Hz, 250 Hz, 1 kHz, 3.5 kHz and 10
kHz. Use this to adjust the sound to the tone quality of
your preferrence, bearing in mind that the acoustic inside
a vehicle differ according to the interior decor and other
factors.
When each knob slid on the '+" side, the sound
corresponding to it's frequency is emphasized, and when
it is slid on the ''—'' side, the corresponding sound is
attenuated. For example, depending on the position of
speakers, the treble may lack in strength but this can be
compensated for if each of the 5 knobs is adjusted
properly.
@LED level indicator [level indicator]
The output levels of the left and right speakers are
indicated with the LED level indicator.
© 4-speaker balance control
(joy stick) knob [balancer]
This is a 4 way Balance/Fader Control. It is used to adjust
the volume balance between right/left channels and
front/rear speakers.
If the control is moved forward, front speaker volume
increases. If it is moved to the rear, rear speaker volume
increases, and when it is moved left to right, the left/right
balance is adjusted.
Adjust this control for well balanced sound when using 4
speakers. If 2 speakers are used, be sure to set this
control in the center of rear/forward positions.
ODimmer button [dimmer]
When this button is turned on (LED lit), the brightness of
the fluorescent display tube® will decrease.
@Loudness changeover button
[loudness]
Low frequencies (bass) become less audible to the
human ear as sound level (volume) reduces.
With this button turned on, the bass as well as the treble
are strengthened when the sound level is low. This will
produce the desired compensation.
"Loudness" effect is, however, reduced as the sound
level on the LED indicator reads more than ''5"'.
© Sensitivity changeover button
[DX-local]
@This enables changeover of FM reception sensitivity.
Normally this is to be set "DX" (with the indicator lit):
®This button should be set "local"? when it is desired to
limit reception to powerful stations.
When the "seek tuning" or "scan tuning" is in
operation, this button can be used to changeover the
sensitivity for automatic frequency stop.
@ Sound attenuation button
[sound attenuator]
This is turned on when it is desired to reduce the sound
level without effecting the adjustment of the volume
contro! button@, for instance, when you talk to another
person.
The sound level is then attenuated to —20 dB.
@ Volume control button and LED
indicator
The "up" button is depressed in order to increase the
volume, and the ''down"' button is depressed in order to
decrease the volume.
One push of the button changes the volume by one step,
and will continuously change if the button is held. The
volume level is visible by the position of the lit LED (1 of
8).
© Band changeover button
This button is used to choose FM or AM.
The LED is lit when FM position is selected.
® Seek button [seek]
When, with this button depressed, the tuning button® (up
or down) is pushed, the tuner will count (up or down) and
stop at the next valid frequency.
@® Manual! button
When, with this button depressed, the tuning button® (up
or down) is pushed, manual tuning is performed.