Simons Voss Technologies PegaSys Door Handle 4.1 Kurzanleitung Seite 49

PegaSys Door Handle 4.1 Reader on both sides
1. For X: measure the door thickness.
11
2. For X: fasten the screws, threaded sleeves and
threaded rods together.
12
3. For X: mark the sawing points on the threaded rods
and spindle.
13
14
4. For X: use a suitable saw to cut the threaded rods
and spindle.
15
8. Programming the fitting
16
9. Installing the fitting
Door pre-drilled.
ü
PH2 screwdriver at hand.
ü
TX15 screwdriver at hand.
ü
Vernier calliper at hand.
ü
Pincers at hand.
ü
1. For S, M and L: measure the door thickness.
17
2. For S, M and L: determine the cutting points on the
cut-to-length screws.
18
3. For S, M and L: shorten the cut-to-length screws.
19
4. For 7 mm spindle: insert the adapter sleeve onto
the side of the spindle with the pin.
20
5. Insert the spindle with the pin side into the fitting.
9 Pin will snap into position in the mount.
21
22
6. For 8.5 mm, 9 mm and 10 mm spindles: slide the
adapter sleeve into the centre of the spindle. Use a
punch and hammer to make an indent in the ad-
apter sleeve to prevent it from slipping.
23
24
EN
7. Insert the outer fitting, with adapter sleeves if ne-
cessary, into the door from the outside.
25
Ø mortise lock fastening
hole
5.5 mm–6.3 mm
6.4 mm–7.3 mm
7.4 mm–8.7 mm
≥ 8.8 mm
8. Insert the escutcheon base into the door with the
sleeve nuts on the outer side.
26
9. Position the adapter plate on the door.
27
10. Align the adapter plate so that the spindle is pre-
cisely centred and the adapter plate is perfectly
perpendicular.
28
11. Screw the adapter plate firmly into place (PH2,
torque 1.1 Nm).
29
12. Screw the escutcheon base into place on the inner
side.
30
13. Insert the dummy cylinder.
NOTE
Feed the blank cylinder into the hole using a screw-
driver
It is difficult to position the blank cylinder correctly, es-
pecially in thick doors.
1. Insert a screwdriver into the hole in the blank cylin-
der.
2. Position the blank cylinder using the screwdriver.
31
32
14. Screw the dummy cylinder firmly into place (PH2,
torque 1.1 Nm).
33
15. Wait five hours for the anti-slip coating to set.
8. Programming the fitting
Adapter sleeves
No adapter sleeves
6.4 mm
7.4 mm
8.8 mm
49 / 68