Werbung
Verfügbare Sprachen
Verfügbare Sprachen
General precautions
•
Do not use this device in locations where the use electronic devices are prohibited.
•
X-ray radiation (e.g., CT/MRI scans) may adversely affect the functioning of this device.
Switch it off before undergoing the procedure and keep it outside the room.
•
High-powered electronic equipment, larger electronic installations and metallic structures
may impair and significantly reduce the operating range.
•
If the sound processor does not respond to the device because of an unusual type of
interference, move away from the source of this interference.
•
Your sound processors and this device were given unique communication codes during
fitting. This ensures that the device will not affect sound processors worn by others.
•
Do not alter or modify this device.
•
Opening the Phone Clip might damage it. If problems occur that cannot be resolved, consult
your hearing care professional.
•
The Phone Clip may only be repaired by an authorized service centre.
•
Do not use the Phone Clip in areas where RF transmission is prohibited, e.g., in airplanes, etc.
•
Only connect the Phone Clip to connections for which it is explicitly intended.
Built-in battery care
Please observe the following:
•
Your product is powered by a rechargeable battery. A new battery performs optimally after
two or three complete charge and discharge cycles.
•
The battery can be charged and discharged hundreds of times, but will eventually wear out.
•
Unplug the charger from the mains socket and the product when not in use.
•
If left unused, a fully charged battery will lose its charge over time.
•
Leaving the product in hot places will reduce the battery's capacity and service life.
•
A product with a cold battery may not work temporarily, even if fully charged. Battery
performance is particularly limited in temperatures well below freezing.
Battery warning
Caution: The battery used in this product may present a risk of fire or chemical
burn if misused.
•
The battery in your product cannot be removed or replaced by the user. Do not attempt to
open the product. Any attempt to do so may result in damage. Using other batteries may
present a risk of fire or explosion and void the warranty.
•
Only recharge the Phone Clip with the recharger that was supplied with the product.
•
Dispose of batteries according to local regulations. Please recycle when possible.
•
Do not dispose of the battery as household waste or in a fire as it may explode.
Charger care
•
Please observe the following if the product is supplied with a charger.
•
Do not attempt to charge your product with anything other than the AC adapter provided.
The use of other chargers may damage or destroy the product and could be dangerous. Use
of other chargers may invalidate any approval or void the warranty.
•
For availability of approved accessories, please check with your hearing care professional.
•
Charge the product according to the instructions provided.
Charger warning
•
When you disconnect the power cord or any accessory, grasp and pull the plug, not the
cord.
•
Never use a charger that is damaged.
•
Do not attempt to disassemble the charger because it may expose you to a dangerous
electric shock.
•
Incorrect reassembly can cause electric shock or fire when the product is subsequently used.
•
Avoid charging your product in extremely high or low temperatures and do not use the
charger outdoors or in damp areas.
•
Do not charge the Cochlear Phone Clip while it is being worn.
Made for iPhone
Made for iPhone means that an electronic accessory has been designed to connect specifically
to iPhone and has been certified by the developer to meet Apple performance standards.
Apple is not responsible for the operation of this device or its compliance with safety and
regulatory standards. Please note that the use of this accessory with iPhone may affect
wireless performance.
Technical specifications
Operating range
Up to 7 meters or more
Power supply
Mains socket
Wireless
2,4 GHz
Bluetooth range
Up to 10 m at clear line of sight
Sound Processor interface range
Up to 3 m at clear line of sight
Operating temperature
0 to 45° C
Storage temperature
-20 to 45° C
Temperature test, transport and storage information
The product is subject to various tests in temperature and damp heating cycling between -25°
C and +70° C according to internal and industry standards.
All manuals and user guides at all-guides.com
Wireless Accessory type designations for models included in
this User Manual are:
FCC ID QZ3BTB-2, IC 8039C-BTB2, IC model: BTB-2
Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Note:
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
•
•
•
•
Changes or modifications can void the user's authority to operate the equipment.
List of countries:
The products are in compliance with the following regulatory requirements:
•
•
•
•
•
•
•
•
•
•
•
This equipment has been tested and found to comply with the limits for a Class B
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
In EU: the device conforms to the Essential Requirements according to Annex I of
Council Directive 93/42/EEC for medical devices (MDD) and essential requirements
and other relevant provisions of Directive 1999/5/EC (R&TTE). The declaration of
conformity may be consulted at www.cochlear.com
Products with wireless functionality are intended for sale in countries within the
European Economic Area as well as Switzerland. Specification of restrictions: You
are not allowed to operate the equipment within 20 km of the center of Ny Ålesund,
Norway.
In US: FCC CFR 47 Part 15, subpart C, section 15.249.
Other identified applicable international regulatory requirements in countries outside
the EU and US. Please refer to local country requirements for these areas.
Products are in compliance with EN 300 328.
In Canada the Phone Clip is certified under the following certification number:
IC:8039C-BTB2.
This device complies with Industry Canada license-exempt RSS standard(s).
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil
numérique de la classe B est conforme à la norme NMB-003 du Canada.
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur
de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Equipment includes RF transmitter.
BTB-2: MSIP-CRI-1CK-BTB-2
해당 무선 설비는 전파혼신 가능성이 있으므로 인명안전과 관련된 서비스는 할
수 없음
**
Note: Feature only available to Baha Sound Processor users.
Werbung
