HEYLO DE2XL Betriebsanleitung Seite 27

device. Do not use near curtains or other ob-
jects that can block the air inlet opening.
– Do not use near open fires or heat sources.
– Do not use or store in areas where combus-
tible gaseous, air or dust-air mixtures could be
produced, or in aggressive atmospheres.
– Do not use in areas where the device can suck
in flammable small parts such as wood shav-
ings or straw.
– The device should not be exposed to signifi-
cant dust emissions. Dust deposits on the
heating element can cause a short-circuit
when moisture is also present.
14.3 Operating conditions
Under inadmissible operating conditions, the
operational safety and the performance of the
device may not be sufficiently ensured. Inad-
missible operating conditions must therefore be
avoided at all times.
When installing the device, the respective local
building, fire prevention and trade association
regulations must always be adhered to. Different
ambient conditions can pose different dangers.
Installation location
The device must not be connected to air ducts or
hoses.
The following safety clearances to flammable
fume parts must be strictly observed:
– Lateral: 0.60 m
– Outlet side: 2.00 m
– Inlet side: 0.20 m
– Upwards: 2.00 m
The following principles apply to the place of in-
stallation and to installing the device:
– The device is designed for the heat-
ing/ventilation of closed rooms.
EN
– The device must not be used in rooms and en-
vironments with explosive atmospheres, com-
bustible liquids or gases.
– Do not use the device outdoors in damp
weather, in bathrooms or in other damp envi-
ronments.
– The device must never be operated in the im-
mediate vicinity of bathtubs, showers, wash
basins or swimming pools.
– The floors and ceilings at the place of installa-
tion must be fire retardant.
– A sufficient safety clearance to flammable ob-
jects such as furniture, curtains and the like
must be maintained.
– The intake and outlet nozzles of the device
must not be narrowed or covered. The safety
clearances must be observed.
The device must not be covered with textiles
and the like (e.g. curtains).
– The device must be installed in an upright and
stable way.
– The mains voltage must correspond to the de-
tails on the rating plate.
– Extension cables must be selected according
to the performance data on the rating plate, in
order to prevent overload.
Keep extension cables as short as possible
and only ever use them when they are fully ex-
tended.
– The socket used must be earthed or protected
with an RC circuit-breaker when installed in-
doors.
– Only ever operate one device from one socket
to prevent overloading.
– Do not switch the device on automatically with
a timer or similar device.
– Monitor the device during operation and keep
children and pets at a safe distance.
The following principles apply to handling the de-
vice:
Electric heater DE2XL
25 / 36