Fuel; Instructions For Battery Operation; Protection Of The Environment; Operating Conditions - HEYLO IR 20 H Betriebsanleitung

Infrared oil heater IR 20 H (battery)
– Do not install or operate the device in atmos-
pheres containing oil, sulphur or salt vapours.
13.2

Fuel

NOTICE
Admissible fuel
The device must only be run with diesel or petrole-
um.
The use of a suitable fuel (see Technical data and
factory settings [ 40]) minimises the risk of fire and
explosion. Never use benzene, paint stripper, alco-
hol or other highly flammable fuels.
At temperatures below 5 °C, use only fuels that are
stable up down to a temperature of approx. -20 °C,
such as winter diesel or polar diesel conforming to
DIN EN 590.
13.3

Instructions for battery operation

– Before using the battery, read the instructions
and warnings attached to the battery and the
charger.
– Never operate the device with a damaged or de-
fective battery.
– Protect the battery from impacts, and do not
drop it.
– Do not open or disassemble the battery.
– If you notice that the battery life is much shorter
than expected, shut down the device without de-
lay. Otherwise, there is a risk of overheating or
even explosion.
– Never short circuit the battery:
– Ensure that the battery contacts do not come
into touch with an electrically conductive ma-
terial.
– Do not store the battery together with metal
objects such as nails, coins, etc.
– Keep the battery dry at all times.
– A short circuit in the battery leads to very high
currents, which in turn can cause overheating,
damage to the battery and injury from burns.
– Do not expose the battery to temperatures of
50 °C or higher.
– Do not incinerate the battery, even if it is dam-
aged or can no longer be charged. When set a-
light, the battery might explode.
– In case of electrolyte in the eye, rinse the eye
with clean water and immediately seek medical
attention. Otherwise, there is a risk of permanent
sight loss.
– Lithium-ion batteries are subject to the statutory
regulations that govern hazardous substances.
For commercial transport, e.g. by courier ser-
26 / 42
vice, etc., the packaging and labelling must meet
specific requirements. Observe the applicable
statutory regulations.
Do not tape over or otherwise cover exposed
contacts, and pack the battery so that it cannot
move inside the packaging.
– Strictly follow the statutory regulations for the
disposal of batteries.
– Only use the battery for products for which it has
been approved by HEYLO. Do not use the bat-
tery in products for which it has not been ap-
proved, as this can lead to fire, overheating, ex-
plosion or electrolyte release.
Maintaining maximum battery life
– Recharge the battery before it has been fully
discharged. Regularly check the charging level
indicated by the batter charge indicator on the
battery.
If the battery is low, switch off the device and re-
charge the battery in the charger.
– Charge the battery at a room temperature be-
tween 10 and 40 °C. If the battery is hot, allow it
to cool down to this temperature. If the battery is
colder than 10 °C, bring it to room temperature
before charging it.
– If the battery is not to be used for more than six
months, charge it fully before putting it into stor-
age.
13.4

Protection of the environment

Safety-conscious and forward-looking action on the
part of the personnel helps prevent damage to the
environment.
To protect the environment, observe the following
general rules:
– Never release environmentally hazardous sub-
stances released into the ground or the sewer-
age system.
– Observe the statutory regulations for waste pre-
vention, disposal and recycling.
– Always store environmentally hazardous sub-
stances in appropriate containers, and label the
containers accordingly.
13.5

Operating conditions

The device has been designed for stationary or non-
stationary operation in well-ventilated rooms (e.g.
halls) or outdoors (e.g. construction sites).
Under inadmissible operating conditions, the operat-
ing safety and performance of the device cannot be
guaranteed. Such operating conditions must there-
fore be avoided in all circumstances.

Place of installation

For the installation of the device, observe the follow-
ing general rules:
EN