HEYLO DE2XL Betriebsanleitung Seite 33

NOTICE
Process sequence
After switching on the device with the
mode
rotary switch, the device independently
regulates the running times of the device compo-
nents (fan, heating). Information about this can
be found in the Section Operating modes
a) Select the desired operating mode on the ro-
tary selector.
 The heating element and the fan start up.
b) Set the desired heating temperature with the
rotary knob.
 The air is heated at the outlet side.
 You have now switched on the device.
Switching the device off
Heating temperature
a) Set the
the Min position.
Operating mode
b) Move the
the Ventilate position.
 Allow the device to run for approx. two
minutes until it has cooled down.
Operating mode
c) Move the
the 0 position.
During prolonged downtime: Pull out the
mains plug.
 You have now switched off the device.
See also
 Malfunctions during operation
18.2 Operating modes
The operating mode can be used to select the
heating output. The device emits the intake air in
heated form (Heat 1000 W or Heat 2000 W).
The operating mode can only be selected with the
Operating mode
rotary selector.
EN
Operating
[ 31].
rotary knob to
rotary selector to
rotary selector to
[ 32]
Operating mode Heat (1000 W)
Operating mode
– Move the
position 2 (Heat 1000 W).
– The fan and the heater are switched on and
are conveying and heating up the intake air.
– The desired temperature is set with the
ing temperature
rotary knob.
NOTICE
Single-sided warming of the heating ele-
ment
In the 1000 W mode, one half of the heating ele-
ment remains cooler than the other half. This is a
normal operating condition.
Operating mode Heat (2,000 W)
Operating mode
– Move the
position 3 (Heat 2,000 W).
– The fan and the heater are switched on and
are conveying and heating up the intake air.
– The desired temperature is set with the
ing temperature rotary knob.
19 Faults
Observe the following principles if you looking for
the causes of faults and want to eliminate them:
These tasks may only be carried out by trained
and authorised specialists.
Interventions may only be carried out by the man-
ufacturer or by persons authorised by the manu-
facturer during the statutory warranty period.
a) Let the device cool down.
b) Wear suitable protective clothing.
c) Before recommissioning, install all the safety
devices as attached at the factory.
d) Check that the safety devices are functioning
properly.
Electric heater DE2XL
rotary selector to
Heat-
rotary selector to
Heat-
31 / 36