HEYLO DE2XL Betriebsanleitung Seite 26

Electric heater DE2XL
Instructions for operation
The following principles apply during operation:
– Do not modify, dismantle or take any safety
devices out of operation. All safety equipment
must be checked at regular intervals.
– All the covering panels, covers and hoods must
be installed as intended.
– Structural changes to the device are not al-
lowed.
– The device must not be operated if the power
cable is damaged.
– Never pull on the cable, but grasp the plug and
pull it out.
Never touch the plug with wet or damp hands.
– Children aged 8 or over and persons with re-
duced physical, sensory or mental capabilities,
lack of experience or knowledge may only use
this device if they are supervised or have been
instructed on how to use the device safely and
understand the dangers. Children must not
play with the device.
– Children between three years and eight years
may only switch the device on and off if it has
been set-up or installed in the normal, intend-
ed operating position, if they have been in-
structed on how to safely use the device and
understand the dangers associated with the
device. Children between the ages of three
and eight years must not connect up, operate,
clean or maintain the device.
– Children up to three years must be kept away
from the heater if they are not continuously
monitored.
Maintenance and troubleshooting
instructions
The following principles apply for troubleshooting.
– Only suitably trained and qualified staff may
perform such work on the device.
24 / 36
– Cleaning and maintenance may not be carried
out by children without supervision.
– The mains plug must always be disconnected
before opening the housing for cleaning and
maintenance purposes.
– The device should always be allowed to cool
down before work is started.
14.1 Information on electrical
equipment
During all work on electrical equipment, the fol-
lowing principles shall apply:
– The device is operated electrically. There is a
risk of fatal injury from faulty installation of
the electrical system or from a breakdown of
the insulation during operation.
– Only electricians are allowed to access and
work on electrical equipment.
– Pull the mains plug out of the socket to dis-
connect the device from the mains supply.
– Only insert the mains plug into sockets that
are protected by an RC (residual current) cir-
cuit-breaker.
– Never interrupt the earthing.
14.2 Notes on fire protection
The device is equipped with a safety thermostat.
This switches the device off in the event that it
overheats (the operating temperature is exceed-
ed). Eliminate the causes of overheating, let the
device cool down, unplug the device from the
mains and operate the safety temperature limiter
on the bottom of the device, observe the following
precautions:
– WARNING! To prevent overheating, never
cover the device.
– Keep the air inlet and protective grille free of
obstructions and dirt. A reduced air flow can
lead to overheating of the components or the
EN