Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6
OPTIONALS
Parts listed below can be standard equipment in your ar-
ea: contact your dealer.
In
stall in accordance with the assembly/installation in-
structions of the respective option.
For spare parts see IPL.
6.1 General instructions for ordering
parts
Your order for parts should contain the following
information:
-
machine type and product series number (PSN) or the
product identification no. (PIN),
-
description, part number (see IPL) and quantity in
question.
If in doubt send a rough sketch of the part clearly marked
with your name and address.
Attention:
Take into account Errata and other supplements!
Contact your dealer!
6.2 Spacer set
part no. 'ST0053'
This set consists of 4 8 mm thick rings (2 per sliding saucer),
for use of these rings refer to sect. 3.5
6.3 Depth limiting chain (pivotstar)
part no. 'XF00139'
If you want (or must) to be sure the sub frame of the mower
keeps the same height we recommend fitting this chain.
When the mower has been lifted using the wheel cylinders,
the chain will prevent inadvertent lowering of and damage
to the mower in the event of leakage in the hydraulic system
of the power lift. Mount this chain on the pin on the inside of
the carrier frame (mower inside) and to the top link mount
(tractor side).
6.4 Gradual cutting height adjustment
set
part no. 'ME0015K0'
This set provides gradual cutting height adjustment through
rotating skid saucers. This set is basically meant for the outer
drums but it can be additionally fitted to the inner drums as
well.
For fitting see installation instruction drawing MO144
which is a part of the set.
Use (see drawing MO144):
Place the blade detachment tool into the brace between
skid saucer and drum skirt, hold it tight and then rotate the
skid saucer as required. You will feel a resistance and when
you continue rotation the cutting height is increased by one
step of 10 mm (one click). A total adjustment of 30 mm can
be obtained.
G0309MKA3
.
EN27
Werbung
