Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3
MOWING INSTRUCTIONS
3.1 General
Attention:
Check protection prior to commencing work and
1
ensure it is in protective position. Repair or renew
damaged protection!
Repair or renew damaged parts prior to start or
2
continue working with the mower!
Regularly check blade holder pins for deteriora-
3
tion / wear!
Always work using manual throttle control!
4
Select a gear which allows an even stubble to be left.
1
Always use sharp blades for maximum efficiency. Ensure
2
blades are seated correctly over pins of blade holders.
Regularly check blade holders: if pins are more than
half worn (left less than 6.5 mm; 1/4") as shown in fig.
then renew the blade holders! Always exchange all
blades or blade holders resp. per drum skirt! Ensure the
blade holders of a drum skirt have the same part
number! Ensure the crop transport strips have not been
worn too much
Drums must be rotating at full working speed (Pto speed
3
1000 rpm) before entering crop.
The best mowing results will be obtained when the
4
mower is level or pitches just a touch forward. Adjust the
to provide this. The skid saucers are then operating in
their optimum position. This adjustment is made by way of the spindle located on the drawbar hinge (see the illustration
below):
To reduce the cutting height: turn nut (4) clockwise. Turn nut (5) clockwise. The mower will fold to the rear.
1
To increase the cutting height: turn nut (5) counterclockwise. Turn nut (4) counterclockwise. The mower will fold to the
2
front.
Attention:
To prevent recutting of the stubble, the mower should never be tilted backwards!
Ensure the lift cylinder is in floating position when mowing
3
G0309MKA3
EN12
Werbung
