Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2
PREPARATION
2.1 Adaptation to the tractor - fixed
drawbar
The machine must only be connected to the swinging
1
drawbar. of the tractor. If possible the double strap on
the tractor side and the single strap on the machine
side should be used. If this hitching option is not realiza-
ble, the single strap on the tractor side and the double
strap on the machine side can be used. Make sure the
strap(s) on the machine side are positioned in a way
that the machine is rather horizontal. Drawbar height
should then be about 50 cm (19 2/3 in). Choose a
tractor suitable of transporting and working with this
machine!
Connect pto drive shaft. The freewheel clutch of the pto
2
drive shaft must be at the machine side.
If necessary shorten the pto drive shaft between tractor
and mower to prevent damage when it is in its shortest
position. Ensure it is shortened correctly and to the
exact length (see fig. and the instructions at the shaft).
Connect the hydraulic hoses of the drawbar cylinder to
3
a double acting spool valve. Connect the hydraulic
hose of the wheel cylinders to a single acting spool
valve. If the tractor is only fitted with a double acting
spool valve, a diverter valve must be installed (optional
equipment, see 6.5).
a) Fully retract the support jack (1) using crank (2).
4
b) Pull out jack stand (1) against the spring resistance
and rotate it 90° to the right.
c) Place the jack stand (1) in its transport position with
the crank (2) in the holder (3).
Attention:
Jack stand must always be placed in transport posi-
tion when the mower is mounted to the tractor.
G0309MKA3
EN9
Werbung
