Nibe VVM S325 Installateurhandbuch Seite 60

General
This accessory, which includes a freestanding electric
control module, is used to allow pool heating with a
compatible product. The indoor module controls the re-
versing valve (QN19), the circulation pump (GP9) and
the charge pump (GP12).
COMPATIBLE PRODUCTS
Caution
In order for the accessory to work, a NIBE
air/water heat pump must be connected to the
system.
• VVM 225
• VVM 310
• VVM 320
• VVM 325
CONTENTS
1 x Charge pump
1 x PWM cable for circulation pump
1 x Power cable to circulation pump
2 x Ball valves with union nut
2 x Flat gaskets
2 x Cable ties
1 x Actuator reversing valve
1 x Shuttle valve
1 x AXC module
1 x Heating pipe paste
1 x Aluminium tape
1 x Insulation tape
2 x Temperature sensor
60
MOUNTING
Caution
The screw type must be adapted to the surface
on which installation is taking place.
Use all mounting points and install the module upright,
flat against the wall, with no part of the module protrud-
ing beyond the wall.
Leave at least 100 mm of free space around the module
to allow access and make cable routing easier during
installation and servicing.
NOTE
The installation must be carried out in such a
way that IP21 is satisfied.
POOL 310 | GB