Connecting The Thermostat In The Application - TERMOFOL TF-WIFI Mark II Benutzerhandbuch

the user specifies the country of installation and enters the e-mail address or telephone
number to which the verification code will be sent. After completing this data, the verification
code sent should be read from the e-mail or SMS message received, and completed on the
next application registration screen. The user completes the registration process by setting a
password for the account, which we will use to log in to our account in the application from
now on. Registration is complete and you can move on to adding the device - connecting the
thermostat.
PREPARING THE THERMOSTAT FOR CONNECTION TO THE WI-FI NETWORK
Before starting the process of adding the thermostat in the application, you need
to enable Wi-Fi and Cloud synchronisation. To do this, with the thermostat swi-
tched on, press and hold the SET and OK buttons simultaneously for 5-20 se-
conds until the flashing symbols appear on the left-hand side of the screen:
. The thermostat is ready to connect to the Wi-Fi network.

CONNECTING THE THERMOSTAT IN THE APPLICATION

Having prepared the thermostat, launch the TERMOFOL SMART application and upon logging
into the application on the main screen, select the function 'add device'.
On the next screen select the thermostat icon and on the subsequent screen select the option
'confirm fast flashing of the display' and select the 'next' button. On the next screen, enter the
access password to the Wi-Fi network to which you are connecting the thermostat and confirm
by selecting the 'next' button. The connection process is fully automatic and its progress can be
followed on the screen displaying the time progress and on the 3-point axis indicating the suc-
cessive stages of the connection establishment. When the connection process is completed,
the progress indicator will reach level 3 and then a screen will automatically appear informing
you that the device was successfully added and allowing you to change the name of the device
under which it will be displayed in the application. Confirm the process by clicking 'Done' in the
upper right corner of the application screen. On the screen of the thermostat, you will notice
that the previously flashing symbols: , are now displayed in a permanent manner.