Herunterladen Diese Seite drucken

STIEBEL ELTRON DHF 18 Gebrauchs- Und Montageanweisung Seite 19

Vorschau ausblenden Andere Handbücher für DHF 18:

Werbung

English
Electrical connection
– For a concealed connection, the connec-
tion line must protrude from the wall by a
minimum of 30 mm properly insulated
(Fig. 8).
• Electrical Connection Bottom Entry
Appliance is supplied ready for bottom
entry (see fig. 10).
– Cable protection tube must be fitted to
guard against moisture.
– Ensure that cable of the appropriate size
is used.
For completion see page 23.
Legend (fig. 9)
1, 2 and 3 Heating system / Heater
F1 Safety thermal cut-out
N1 Water flow operated power
switch
1) Switching stage I = 2 switch
lanes on the right side
2) Switching stage II = 1 switch
lane on the left side
Français
Raccordement électrique
– Laisser dépasser le câble d'alimentation
non dénudé d'au moins 30 mm du mur
(fig. 8) en cas de raccordement sous crépi.
• Raccordement électrique en partie
inférieure
Le chauffe eau instantané DHF est équipé
d'usine pour un raccordement en partie
inférieure (fig. 10).
– Montage suivant la figure 10.
– Pour réaliser l'étanchéité contre les
infiltrations d'eau, le passe-câble (rep. 1,
fig. 10) fourni doit être mis en place.
– Raccorder le câble d'alimentation au
bornier (rep. 10, fig. 3 conformément au
schéma figure 10.
Pour terminer le montage, voir page 23.
Légende (fig. 9)
1, 2 et 3 Systéme de chauffe / résistance
F1 Limiteur de temperature de
sécurité
N1 Pressostat différentiel
1) Niveau de puissance I = 2
contacts côté droit
2) Niveau de puissance II = 1
contact côté gauche
Nederlands
Elektrische aansluiting
– Bij inbouw-aansluiting moet de
aansluitleiding tenminste 30 mm
geïsoleerd uit de muur naar voren
komen (afb. 8).
• Elektrisch aansluiting in onderste deel
van het toestel.
Het toestel wordt standaard geleverd
voor elektrische montage onder in het
toestel (afb. 10).
– Monteren zoals afb. 10 laat zien.
– Als bescherming tegen binnendringend
water moet de meegeleverde kabeltule
worden gebruikt.
– Aansluitleiding overeenkomstig afb. 10 aan
de aansluitkroonstrip aansluiten.
Montage beëindingen, zie blz. 23.
Legende (afb. 9)
1, 2 en 3 verwarmingssysteem /
verwarmingselement
F1 temperatuurbeveiliger
N1 drukverschilschakelaar
1) schakelniveau I = 2 schakel-
symbolen aan de rechterzijde
2) schakelniveau II = 1 schakel-
symbool aan de linkerzijde
19

Werbung

loading

Diese Anleitung auch für:

Dhf 21Dhf 24Dhf 27