Sharp VC-FH3GM/SM Serviceanleitung Seite 9

VC-FH3GM/SM
VC-FH5GM
4. ADJUSTMENT, REPLACEMENT AND ASSEMBLY OF MECHANICAL UNITS
r=] sane =
©
° o
fe)
measuring jig
This cassette torque meter is used for check-
1. |Torque Cassette Meter
JIGVHT-063
| CZ
ing and adjusting the torque of take-up for
measuring tape back tension.
JiGTGOO90
2.
|Torque Gauge
ee
'
ache
9
N
ese Jigs are used
for checking
gla and adjusting the torque of take-up
and supply reel disks.
3. |Torque Gauge Head
JIGTHOOO6
=| AW
When fixing any part to the threaded
4. | Torque Driver
JiGTD1200
CB
hole using resin with screw, use the
jig. (Specified torque 5 kg)
Master Plane Jig ang
JIGRH0002
/BR
These Jigs are used for checking
5. | Reel Disk Height
and adjusting the reel disk height
Adjusting Jig JiGMP0001 BY .
JiGSG2000
There are two gauges used for the
Tension Gauge
tension measurements, 300 g and
JiGSGO300
2.0kg.
Pinch
presse tenes
This Jig is used with the tension
7. P
g JiGADPO03
=| BK
gauge. Rotary transformer clearance
adjusting jig.
This Jig is used for height adjustment of the
reverse guide (for reverse guide height ad-
justment).
AR
1)
=)
Guide roller height P ;
adjustment sihie JiGDRIVERH-4
X value adjustment ,
This screwdriver is used for adjusting the
guide roller height
For X value adjustment
This Jig is used for height
adjustment of the reverse guide.
and
Sy
'IHL