Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
42
continue to flash. The coffee machine beeps for 5 seconds, and any function
buttons will be invalid in this state. After 30 seconds of alarm, the coffee
machine automatically enters standby mode, and all indicator lights turn off.
2.
In the absence of water in the water tank, the coffee machine works for a
period of time until it stops, and "Clean/Descale" ->"Espresso" ->"Froth/
Cappuccino" ->"Latte" ->"Clean/Descale" is displayed in a cycle without any
operation. After 15 seconds, the machine automatically enters standby mode.
After the water tank is refilled, the coffee machine will be operated again.
Note: When the coffee machine is in a protection state for water shortage in the
water tank, please make coffee after the water tank is refilled. If no milk foam or
coffee flows out during this process, please stop making coffee immediately. You
can try pressing the "Clean/Descale" button once to enter the cleaning mode of
milk foam system.
3.
If the milk tank is not installed in place or its micro-switch is found short circuit
or open circuit, the indicator lights of "Froth/Cappuccino" and "Latte" buttons
will turn off.
Notes
•
There is a need for a close guard during making coffee.
•
Do not remove the funnel of the coffee machine while the machine is
extracting coffee to prevent spillage.
•
The lip of the milk foam generator cannot be placed on the surface of the milk
to avoid being burnt, which will cause the milk to splash.
•
The function of cleaning the milk foam system should be used in time and it is
needed to clean the milk foam generator with a wet cloth to avoid the residual
milk sticking to the milk foam generator after foaming.
•
The function of cleaning the foam system must be used at least once after
foaming.
Descaling
1.
After the machine is used for a period of time, the indicator light of "Clean/
Descale" button will flash quickly, signifying that the machine needs to be
descaled. (Default descaling: descale after 1000 times of coffee brewing)
2.
After the machine gives an alarm, users should add descaling solution to the
water tank. The descaling solution to be poured should be diluted according
to the instructions on the package (the ratio of water to descaling agent
is about 4:1, or subject to the instruction for use. If no descaling agent is
available, "citric acid" can be used instead, with the ratio of water to citric acid
of about 100:3). Add 0.5L of water to the water tank, fill the milk tank with
water, and put a container of suitable size below the outlet of the milk foam
generator. After the machine is preheated, press and hold the "Clean/Descale"
button for at least 3 seconds, and then the machine enters the descaling
mode. The indicator light of "Clean/Descale" button starts to flash. The coffee
machine circulates water from the milk foam generator and coffee outlet, and
Werbung
