Restore Default Status - pyrexx PX-AR Betriebsanleitung

7 Restore default status

(1) To set the PX-AR into default sta-
tus, press and hold the configura-
tion button for approx. 20 seconds.
During these 20 seconds, the LED
produces various optical signals at
different intervals:
1
At the start, a continuous
•
yellow interval signal
Then a slowly flashing
•
yellow interval signal
Finally a quickly flashing
•
yellow interval signal
EN
2
20 sec.
Operating Manual: PX - AR Alarm Relay
(2) Now release the button
(3) The Status-LED
lights up green briefly
5 The device is now in the default
status
3
The default status can only be re-
stored if the PX-AR is in the status
that was given, when the PX-AR was in-
tegrated into the radio group.
Example: When the PX-AR was inte-
grating and the contacts were bridged,
during the reset, the contacts must also
be bridged.
If it isn't possible to reset the device,
open it with a screwdriver and care-
fully remove the cable of the batterie. In
this case, please send the device back to
us, so that we can check it.
4
33