Connectivity; Connection Test - pyrexx PX-AR Betriebsanleitung

5 The PX-AR is now successfully
integrated into the radio group.
f To end the learning mode, press the
configuration button briefly once,
or wait for 10 minutes.

5 Connectivity

With other radio group
participants:
You cannot set a radio group into
•
learning mode via the PX-AR!
Using the PX-AR, the alarm
•
of a radio group cannot
be muted or ended.
32

6 Connection test

(1) Press and hold the test/stop
(2)
5 The connection test is then
Operating Manual: PX - AR Alarm Relay
The PX-AR cannot perform
a connection test automati-
cally. However, you can use
the connection test function
of a PX-1C to test the ra-
dio connection to the PX-AR.
To start the connection test
button on a PX-1C for approx.
12 seconds.
All the participants in the radio
group will now produce a signal
one after another. The PX-AR
also acknowledges the connec-
tion test with a flashing red LED.
successfully ended.
EN