Parkside PMFS 200 C3 Originalbetriebsanleitung Seite 48

Dust box
Connecting
♦ Slide the dust box
sure that the symbol on the dust box
aligned with the ▸ symbol on the appliance.
Turn the dust box
(see detailed illustration fig. D on the fold-out
page).
Removal
♦ Turn the symbol on the dust box
▸ symbol on the appliance (see detailed illustra-
tion fig. D on the fold-out page). Pull the dust
box off the appliance.
NOTE
► To achieve optimum dust extraction, the dust
box should be emptied regularly.
♦ To do this, remove the dust box
appliance as described above. To do this,
open the dust box
button and pulling off the rear part. Now
remove the dust bag
thoroughly by tapping it out.
■ 44 │ GB │ MT
onto the appliance. Make
is
to the symbol to lock it
to the
off the
by pressing on the release
. Clean the dust bag
Reducer
Connecting
♦ Push the reducer
♦ Push the hose of a suitable of vacuum cleaning
appliance (e.g. a workshop vacuum cleaner)
onto the reducer
Removal
♦ Pull the hose of the vacuum cleaner off the
reducer .
♦ Remove the reducer
Use
CAUTION!
► Ensure that the appliance is switched off
before connecting it to the mains.
NOTE
► Always switch the multi-sander on before
applying it to the material, then move it over
the workpiece.
Switching on and off
Switching the appliance on
♦ Move the ON/OFF switch
tion.
Switching the appliance off
♦ Move the ON/OFF switch
Setting the oscillating speed
You can set the desired oscillating speed using the
speed selector as required. The required speed
depends on the material being processed and can
be determined through practical tests.
into the adapter fitting
.
.
in the "I" posi-
in the "0" position.
PMFS 200 C3
.