Parkside PMFS 200 C3 Originalbetriebsanleitung Seite 47

♦ Re-tighten the four screws
key .
♦ Check that the sander plate is fitted securely.
Selecting a sanding sheet
Removal and surface
The material removal rate and surface quality are
determined by the grain strength of the sanding
sheet.
♦ Please note that you need to use appropriate
sanding sheets with different grains for working
different materials.
Fitting the sanding sheet
WARNING!
► Always remove the plug from the mains
power socket before carrying out any work
on the appliance.
NOTE
► Before fitting a new sanding sheet, remove any
dust and dirt from the sander plate
Attaching sanding sheets using Velcro
♦ You can attach the sanding sheet to the sander
plate using Velcro.
♦ Ensure that the extraction holes on the sanding
sheet match up with those on the sander plate.
Removing sanding sheets fitted using Velcro
♦ Simply pull the sanding sheet off the sander
plate
(see fig. A on the fold-out page).
Attaching sanding sheets without using
Velcro (see fig. B on the fold-out page, not
supplied)
♦ Open the two clamping levers
♦ Push the sanding sheet under the open
clamping rail at one end and clamp it firmly
in place with the clamping lever.
♦ Follow the same procedure at the other end.
PMFS 200 C3
using the hex
.
.
Dust extraction
WARNING! RISK OF FIRE!
► When working with power tools that have a
dust collection box or can be connected to a
vacuum cleaner via the vacuum cleaner
adapter, there is a risk of fire! In unfavourable
conditions, e.g. when sparks are flying while
sanding metal or metal residues in wood,
wood dust in the dust sack (or in the vacuum
cleaner dust bag) can spontaneously ignite.
This is a particular risk if the wood dust is
mixed with paint residues or other chemicals
and the workpiece has become hot after
being worked for a long time. Therefore, do
not allow the workpiece to overheat and
always empty the dust box or the dust bag of
the vacuum cleaner before taking a break
from work.
Wear a dust mask!
NOTE
► Perforated sanding sheets are required for
dust extraction.
GB │ MT │ 43 ■