Cleaning Stop - WimTec OCEAN W6 Montage- Und Bedienungsanleitung

EN
OCEAN W6
Program description

Cleaning stop:

DIP switch 3
Serves to disable automatic activation prior to cleaning.
DIP switch 3 ON = Cleaning stop function enabled (default setting).
DIP switch 3 OFF = Cleaning stop function disabled.
Enable cleaning stop
Position your hand in front of
the infrared sensor (below
the spout). The illuminating
icon begins to pulse and
water flow starts.
After blinking 5 times the
water flow stops and cleaning
stop function is enabled.
While the cleaning stop
function is enabled, the
illuminating icon will light up
every 3 s.
5 x Blinking
28 Wall tap control
Disable cleaning stop
The fitting will resume normal
operation 3 min after the
sensor has remained un-
triggered.
To instantly end the cleaning
stop, perform the same steps
used to enable the function.
WimTec OCEAN W6
Werkseinstellung:
ON
ON
OFF
OFF
1 2 3 4 5 6
ON
ON
OFF
OFF
1 2 3 4 5 6
ON
ON
OFF
OFF
1 2 3 4 5 6
ON
ON
OFF
OFF
1 2 3 4 5 6
ON
OFF
1 2 3 4 5 6
If the manual program is enab-
led (DIP switch 2 OFF), you
can only enable the cleaning
stop within the first 3 s after
triggering the water flow.
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
!