WimTec OCEAN W6 Montage- Und Bedienungsanleitung Seite 23

OCEAN W6
Assembly
7
10
7.
Screw out screw M5 and remove the plastic film. Afterwards install spacer for outlet
pipe and fix it with screw M5.
8. Connect the magnetic valve to the electronics module.
For models with thermal disinfection: Connect the lower magnetic valve (red dot)
to the electronics module (cable with red marking).
9. Feed the WimTec power cable 3m (Art.No. 113 167) with the electronics module and
connect it to the power supply (Art.No. 117 899, 113 792). Then turn on the power
supply. (This will cause the safety locking mechanism of the magnetic valve to acti-
vate.) Attention: The power supply must not be installed in the flush-mount set!
10. Fix the mounting frame above outlet pipe.
11. Attach the mounting frame using the 4 screws supplied. Make sure that the cable
connections remain intact and the cables are not crimped. When tightening the
screws, ensure that the mounting frame does not get warped.
8
TD
TD
11
Wall tap control
9
WimTec OCEAN W6
EN
23