WimTec OCEAN W6 Montage- Und Bedienungsanleitung Seite 24

EN
OCEAN W6
Assembly
12
15
!
ATTENTION!
Perform the following steps
in the order indicated!
24 Wall tap control
13
16
12. Correctly align the mounting frame.
Apply the included special grease to the front of the valve.
13.
Configure the desired functions at the electronics module (see
page 20).
14. Check the thermostat position – the arrow should be pointing
upwards.
15. Check the position of the thermostat knob – the locking knob
should be pointing directly upwards.
16. Insert outlet pipe carefully through the glass plate and apply
some pressure while turning it until it is aligned horizontally.
17. Place the plastic spacer ring over the outlet pipe towards the
front plate.
WimTec OCEAN W6
14
17