Parkside Performance PBSPA 12 C3 Originalbetriebsanleitung Seite 27

2. Select:
•
Clockwise rotation: to drill
and screw in screws:
Press the direction switch (4), with
the arrow pointing forwards, in the
handle.
•
Anticlockwise rotation:
to unscrew screws: :
Press the direction switch (4), with
the arrow pointing backwards, in
the handle.
• switch lock: Move the rotation
direction switch (4) into its middle
position.
The direction changed may only be
performed in standstill mode.
Torque setting
You can preset the maximum torque by
rotating the torque adjustment ring (2).
20+1 torque levels are provided.
1. Turn the adjusting ring (2) to select the
desired torque:
Step 1 -->
Step -->
Screws:
Drilling:
2. Start with a lower torque step and
increase according to requirement.
Torque adjustment should only be
performed in standstill mode.
Reaching the preset torque limit pro-
duces a noticeable rasping sound.
This sound is caused by the slip clutch.
Tool change
The automatic spindle lock enables the tool
to be changed even when the motor is at a
standstill.
lowest torque,
highest torque.
Steps 1 - 20
Step
1. Rotate the keyless chuck (1) towards
until the drill chuck aperture
RELEASE
(11) is large enough to accommodate
the tool.
2. Push the tool as far as possible into the
keyless chuck (1).
3. Turn the keyless chuck towards
order to clamp the tool.
4. To remove the tool again, rotate the
keyless chuck (1) and pull out the tool.
Removing the keyless
chuck
To use the bit holder (18), you must remove
the keyless chuck (1).
1. Hold the keyless chuck (1) tightly from
the front. Pull or push the drill chuck
ring (19) in the direction of the keyless
chuck (1).
2. This unlocks the keyless chuck (1) and it
can be pulled off from the front.
3. In order to put the keyless chuck (1)
back in position, pull the drill chuck
ring (19) in the direction of the keyless
chuck. Push the keyless chuck (1) on as
far as it will go.
When attaching the keyless chuck,
a 25 mm bit may remain in the bit
holder (18).
If the keyless chuck (1) does not
engage automatically, turn the drill
chuck ring (19).
Using the bit holder
After removing the keyless chuck (1) you
can use the bit holder (18).
1. Insert a suitable 6-point bit in the bit
holder (18).
GB MT
in
GRIP
27