Coltene CanalPro Apex Locator Gebrauchsanweisung Seite 14

If Virtual Apex feature is enabled, Virtual Apex mark appears on
the left side of the Apical Zoom image.
When the file tip reaches the Virtual Apex position and during
further advance of the file special beeps appear, clearly distinguis-
hed from regular audio signals.
When the real "APEX" is reached the solid tone is sounded, as usu-
al, and an audio warning signal is activated if the file overpasses
the apex.
„ 6.8. Demo mode
The built-in Demo mode is available to demonstrate operation of the device and to improve the learning
curve of the operator.
6.8.1. Disconnect the measuring cable or the charger from the device if
connected and turn the device Off.
6.8.2. To start Demo Mode, press and hold the
about 1 sec. until the second beep sounds and "Demo" indication
appears on the status bar.
6.8.3. During Demo cycle the operating sequence of the device is
shown on the screen. Press button to pause the simulation;
press button again to resume.
6.8.4. When Demo cycle is completed, it is repeated automatically until
interrupted by the operator.
6.8.5. To exit Demo mode press button and hold it for about 1 sec.
until a beep sounds.
Note: If measurement cable is connected to CanalPro Apex Locator during Demo cycle, the
device switches automatically to normal operation mode.
„ 6.9. Automatic Shutdown
CanalPro Apex Locator automatically shuts down after 5 minutes without use. In order to prolong the
battery life, it is recommended to switch OFF the device after measuring by pressing the
26
Picture 15
(On/Off) button for
Picture 16
key (On/Off).
7. Battery Charging
The CanalPro Apex Locator is delivered with a rechargeable battery.
Battery indicator on the status bar shows the battery charge level. When the icon is flashing, the battery
requires recharging, however, it is still functional for several treatments before the device shuts down.
„ To charge the battery:
• Disconnect the measurement cable.
• Connect the charger to the mains.
• Connect the charger cable to the CanalPro Apex Locator.
Charging screen will appear during battery charging. Running battery icon animation indicates charging
in process. When the animation on the screen stops and the battery image turns fully green, the charging
is complete.
Picture 17 Picture 18
Charging Charging is completed
Duration of charging: About 12 hours (24 hours after long periods without use).
Note: CanalPro Apex Locator cannot be used while charging.
Warning Use only original battery pack from your supplier!
27