Basic Safety Instructions - bürkert 6650 Bedienungsanleitung

2.1 Restrictions
If exporting the system/device, observe any existing restrictions.
3

BASIC SAFETY INSTRUCTIONS

These safety instructions do not make allowance for any contin-
gencies and events which may arise during installation, operation and
maintenance.
Danger – high pressure.
▶ Before loosening the lines and valves, turn off the pressure and
vent the lines.
Risk of burns/risk of fire if used continuously through hot device
surface!
▶ Keep the device away from highly flammable substances and media
and do not touch with bare hands.
▶ Do not exceed the max. permitted duty cycle (see chapter "4.1 Oper-
ating Conditions")
▶ Do not obstruct the heat dissipation that is required for the
operation.
4
english
Leaking medium when the diaphragm is worn.
▶ Regularly check for leaking medium.
▶ If the media is hazardous, protect the environment from danger.
General hazardous situations.
▶ The flipper solenoid valve type 6650 is not to be used in areas
where there is a risk of explosion.
▶ The connection clamps between coil and fluid housing must not be
removed under any circumstances.
▶ Do not make any internal or external changes to the device.
▶ Do not put any loads on the housing (e.g. by placing objects on it
or standing on it).
▶ Installation and repair work may be carried out by authorised tech-
nicians only.
▶ Ensure that the system cannot be activated unintentionally.
▶ After an interruption in the power supply or pneumatic supply,
ensure that the process is restarted in a defined or controlled
manner.
▶ The device may be operated only when in perfect condition and in
consideration of the operating instructions.
▶ The general rules of technology apply to application planning and
operation of the device.