BWT water+more Bestmax water+more Bestmax S Einbau- Und Bedienungsanleitung Seite 10

6 Initial Installation of Bestmax Water Optimisation Systems
10
Comments:
a) No water should leak out, even without an installed Bestmax Water Optimisa-
tion System and with an open mains supply!! If necessary, check installation!!
b) The filter head must not be under mains water pressure for a long time without
a filter cartridge screwed on.
6.2 Fitting the water+more by BWT Aquameter (Option)
 Read the Aquameter Operating Instructions
Fit the Aquameter directly on the filter head, observe the direction of flow

Fit the water outlet hose to the Aquameter outlet

Check installation for leaks

 Fit the Aquameter display in the sight line
Program the Aquameter according to the Instruction Manual and start it up

6.3 Bestmax Filter Cartridge Installation
Installing a New Filter
A. Determining the Carbonate Hardness
The local carbonate hardness must be determined with the help of the water+more
by BWT Hot Drinks Test Kit (see Accessories) before installation of the filter. The in-
structions must be observed precisely for this. Alternatively, the local water supply
company can also provide information on the typical local carbonate hardness.
6.1 Fitting the Wall-Mounting/Fitting the
Filter Head
Take the filter head with wall-mounting out of

the packaging and check that it is undam-
aged
Remove the wall-mounting from the fil-

ter head and fit at an appropriate place with
screws Ø 5 mm (not included in the deliv-
ery scope)
If an „installation plate" is enclosed, mark the

date (month/year) of initial installation and
stick on the filter head
Fit filter head to wall-mounting. (see Fig. 1 & 2)

Observe the direction of flow!!

Fit the water intake and water outlet hose to

the filter head.
Connect water outlet hose to the equipment

(e.g. coffee machine)
 Shut off mains supply (water intake)
Connect water intake hose to mains supply

Open mains supply and check system for

leaks