Zipper ZI-HS16E Betriebsanleitung Seite 41

16.2 Operating
16.2.1 Splitting lever
Splitting force and splitting speed are controlled by the splitting lever. The splitting lever is simply raised
or lowered for operation.
16.2.2 Splitting
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-HS16E / ZI-HS22EZ / ZI-HS30Z / ZI-HS30EZ
Phase inverter
Check the rotation direction of the motor if necessary
please change direction by using the phase inverter.
(phase inverter inside the plug - see picture on the left)
The first half stroke of the splitting lever is idle speed; press the
splitting lever to the half stroke for maximum splitting force at
slower speed to split the log at the beginning or particularly hard
and seasoned logs.
Press the splitting lever to the end for faster speed at less splitting
force to finish the splitting or to split usual logs.
1. Place the log vertically on the support
2. Hold the left press lever. Meanwhile, move
table, so that it lies flat on its face. Press the
left lever to lower the extended log fixing
claw against the log to secure it. The
extended log fixing claw can be adjusted
to fit logs with different heights.
the splitter wedge down by pressing the
right splitting lever to the half stroke to
split the log slowly first and then press it to
the end until the log is completely split.
OPERATION
41