Indication On The Display; How To Reactivate The [Mode] Button; With Half Duplex Adapter; Without Half Duplex Adapter - sylvac UL III Bedienungsanleitung

VI.3.2 Indication on the display
The symbol 'C' on the display indicates the [mode] button is disabled.
VI.3.3 How to reactivate the [mode] button
VI.3.3.1 With half duplex adapter
Using the half duplex adapter, use the remote command <KEY1> (see VIII.5.1 and the OPTO-
RS instructions for use).
VI.3.3.2 Without half duplex adapter
Activate the fuction 'keyboard lock' is not possible without the use of peripheral equipement.
A reset will deactivate it, but all the introduced parameters will be lost (Refer to
chapter XI).
VI.4 Resetting the instrument
In case of electronic problem, resetting the instrument is advised.
The basic parameters will be reactivated. All the other parameters will be lost.
This function can also be used to deactivate any mode previously activated by retro-command.
Refer to chapter XI.
VII Displayed error messages
In case errors are detected during the measurement, the instrument displays the message
"error" and outputs the message <ERRO>.
66