Selection Of The Functions Min, Max And |Min-Max; Resetting The Min And Max Memory; Tolerance Mode; Introduction Of Tolerance Values - sylvac UL III Bedienungsanleitung

V.4.2. Selection of the functions MIN, MAX and |MIN-MAX|
Press quickly the [mode] button to change the function.
V.4.3 Resetting the MIN and MAX memory
Press quickly the [set] button to clear MIN or MAX displayed values. The displayed value is now
the current value.
Remarks:
- in mode |MIN-MAX| the values MIN and MAX are activated
- prior to clearing the MIN or MAX values, signals are transmitted via OPTO-RS interface
for processing.
V.5 Tolerance mode
In the tolerance mode, the arrows indicate that the measured value shown is outside the preset
tolerances (rework or reject). If no arrow is displayed, measured value is within (good).
V.5.1 Introduction of tolerance values
V.5.1.1 Introduction of the upper limit
Keep [mode] button pressed until tolerance mode is displayed.
62