sylvac UL III Bedienungsanleitung Seite 69

E
<OUT0>, <OUT1>
Deactivates or activates continuous data output.
<OFF>
Turns off the instrument
<ON>
Turns on the instrument
<PRI>, <?>
The instrument returns the displayed value.
Remark: if tolerances mode is active, ASCII code '<', '=' or '>' is added.
<CHA+>, <CHA->
Changes the measuring direction
<CHA?>
The instrument returns the active measuring direction.
<CHA*1>, <CHA*2>
Changes the multiplication factor
<MM>, <IN>
Changes the measurement unit
<RES2>, <RES3>
Changes the resolution:
-<RES2>: 0.001 mm, .00005 " (instrument 0.001 only)
-<RES3>: 0.01 mm, .0005 "
<REF1>, <REF2>
Changes the reference
<PRE>
Recalls the last preset value
<PRE?>
The instrument returns the last preset value
<TOL1>
Activates the tolerance mode
<TOL?>
The instrument returns the tolerance limit values
<MIN>, <MAX>, <DEL>
DEL = Delta = [MAX-MIN] Selection of the dynamic mode
<CLE>
Resets the MIN, MAX memory
69