Switch Off; Battery Replacement; Description Of Use; Measuring Modes - sylvac UL III Bedienungsanleitung

IV.2 Switch off
Press the [set] button for 2 seconds.
It is not possible to switch off the instrument if you are in mode for introduction of tolerances or
preset.
IV.3 Battery replacement
Changing the battery is necessary when indicator 'B' is displayed. (See XI.1)
After introduction of a new battery the instrument will be in mode 'Measure' and should display
0.00 mm.
If this is not correct, proceed with setting procedure. (See XI.1)
V. Description of use
V.1 Measuring modes
V.1.1 Selection of unit of measurement
Press quickly the [mode] button to change reading mm/inch (only applicable to dual units
reading instruments).
58