Metz MECABLITZ 58 AF-2 digital Bedienungsanleitung Seite 126

The shots have shadows in the bottom of the image.
• Because of parallax error between lens and flash unit, close-up shots may not,
depending on the focal length at the bottom of the image, be fully illuminated.
Tilt the main reflector downwards or turn the wide-angle diffuser in front of
the reflector.
The shots are too dark.
• The subject is beyond the range of the flash unit. Note: Using bounce flash
reduces the range of the flash unit.
• The subject contains very bright or highly reflective areas. The metering
system of the camera or flash unit is deceived as a result. Set a positive manu-
al flash exposure correction, e.g., +1 EV.
The shots are too bright.
• For close-ups it is necessary to ensure that certain minimum lighting distances
are maintained to avoid overexposure. The minimum distance from the sub-
ject should be at least 10% of the maximum flash range indicated on the
display.
The flash parameters for ISO film speed and the aperture (f-stop) cannot be
adjusted on the flash unit.
• There is an exchange of digital data between flash unit and camera through
which the ISO and aperture (f) values are automatically adjusted on the flash
unit. In this case the manual setting of ISO and aperture isn't possible!
126
21 Technical data
Max. guide numbers at ISO 100/21°, zoom 105 mm:
In the metric system: 58 In the imperial system: 192
Flash modes:
TTL with measuring preflash, TTL-HSS, Manuel M, M-HSS, Automatic A,
Strobe flash mode, Wireless remote operation
Automatic aperture adjustment at ISO 100/21°:
f1.0 to f45, including intermediate values
Manual partial light output levels:
1/1 ... 1/256 light output, in one-third increments.
Flash durations see table 4, page 199:
Sensor measuring angle: approx. 25°
Colour temperature:
approx. 5600 K
Film speed: ISO 6 to ISO 6400
Synchronisation:
low-voltage ignition
Number of flashes (at full light output):
• Approx. 250 with NiMH batteries 2100 mAh
• Approx. 180 with high-capacity alkaline manganese batteries
• Approx. 430 with Metz Power Pack P76 (special accessory)
Recycling time (at full light output):
• Approx. 4,5 sec with NiMH batteries
• Approx. 4,5 sec with high-capacity alkaline manganese batteries
• Approx. 2,5 sec with Power Pack P76
(at full light output)
(at full light output)