Metz MECABLITZ 58 AF-2 digital Bedienungsanleitung Seite 110

7.3 Flash Bracketing Series (FB)
A series of flash exposures (flash-bracketing FB) can be carried out in the
and automatic A flash modes. A flash bracketing series consists of
three successive flash shots with different flash exposure correction values.
When a flash bracketing series is set, FB and the correction value appear on the
display. The possible correction values range from 1/3 to 3 apertures in one-
third aperture increments.
Setting procedure:
Remote
Select
• Press the
FB
Standby appears on the display.
Set
• Select the menu option „FB" by pressing the
buttons. The selected menu option will be high-
lighted.
• Confirm the selection of the special function by
FB
pressing the
1 1 /
3
• Select the desired setting with the
Set
buttons.
The setting takes effect immediately.
• Press the button
reset to its normal view. If the button
pressed, the display is automatically reset to its nor-
mal view after about 5 seconds.
110
button repeatedly until „Select"
Sel
button.
Set
and
repeatedly until the screen is
is not
• The first shot is taken without a correction
value. „FB 1" will also appear on the
TTL
display.
• The second shot is taken with minus correction.
„FB 2" and the minus correction value
(EV) will also appear on the display.
• The third shot is taken with plus correc-
tion. „FB 3" and the plus correction value (EV)
will also appear on the display.
• After the third shot, the flash bracketing series is automatically deleted. „FB"
will disappear from the display.
When the flash bracketing series is set, the correction value is always
and
shown as a positive value!
Flash bracketing series in the TTL flash mode
A flash bracketing series in the TTL flash mode is only possible if the camera
supports the setting of a manual flash exposure correction on the flash unit (see
camera instruction manual)! Otherwise, the shots are taken without a correction
value!
Flash bracketing in automatic flash mode A
The type of camera is not important for a flash bracketing series in automatic
flash mode A.
7.4 Extended Zoom Mode (Zoom Ext)
In the extended zoom mode, the focal length of the main reflector is reduced to
one level below the focal length of the camera lens. The resulting broader light
coverage provides additional dispersed light (reflections) inside rooms so that a
softer flash illumination is possible.
FB1 TTL FB1
AZoom 28
7.7 m
TTL FB2
1
EV– /
3
AZoom 28
7.7 m EV– 1 /
3