Metz MECABLITZ 58 AF-2 digital Bedienungsanleitung Seite 107

• Set the desired value using the
The setting takes effect immediately.
• Press the button to change the LC display back to the normal view. If the
button is not pressed, the display will change back to the normal view
after about 5 seconds.
Depending on the system, the aperture setting will not be shown on the
display of the flash!
6.2 Main reflector position (Zoom)
If there is no digital data transfer between the camera and flash unit, the reflec-
tor positions
24 mm - 28 mm - 35 mm - 50 mm - 70 mm - 85 mm - 105 mm (35mm format
24 x 36) can be set manually.
MZoom will then appear in the LC display.
Setting procedure:
A
• Press the
MZoom 35
LC display.
11 m ISO 200
Mode Para Sel
• Set the desired value using the
The setting takes effect immediately.
• Press the button
A
the normal view. If the button
MZoom 70
display will change back to the normal view after
15 m ISO 200
about 5 seconds.
+
Para –
During digital data transfer between the camera and
flash unit, the main reflector positions are adjusted
automatically.
AZoom will then appear in the LC display.
+
or – buttons.
button until „Zoom" appears on the
Para
+ or –
to change the LC display back to
is not pressed, the
6.3 Flash exposure correction (EV)
Manual flash exposure correction (EV) can help offset extreme differences in
contrast between the subject and background. Corrections from -3 f-stops (EV)
to +3 f-stops (EV) can be made, in 1/3 increments (also see 10.5).
Setting procedure:
• Press the button until „EV" flashes on the
Para
LC display.
• Set the desired EV value using the
+ or buttons.
–
The setting takes effect immediately.
• Press the button
the normal view. If the button
display will change back to the normal view after
about 5 seconds.
buttons.
to change the LC display back to
is not pressed, the
F 8.0
A
MZoom 35
12 m EV 0
+
Para –
A F 8.0
MZoom 35
6,1 m EV+2
+
Para –
107