Metz MECABLITZ 58 AF-2 digital Bedienungsanleitung Seite 109

• Press the
selection.
1/1
• Choose the setting desired using the
Set
arrows.
The setting takes effect immediately.
• Press
mal reading. If the button
display will change back to the normal view after
about 5 seconds.
7.2 Beep function (Beep)
The beep function allows the user to receive an acoustic signal for certain func-
tions of the flash unit. This allows the photographer to concentrate fully on the
subject and taking the picture, and not have to worry about any optical status
indicators.
The beep function signals when the flash is ready, when the correct flash expo-
sure has been reached, or when an error occurs.
Acoustic signals after the flash unit has been turned on:
• A short (about two seconds) uninterrupted beep signal after turning the flash
on indicates that the flash unit is ready.
Beep signals after taking a photograph:
• A short (about two seconds) uninterrupted beep signal directly after a picture
is taken indicates that the shot was exposed correctly and the flash is ready
again. If no beep signal sounds, then the shot was underexposed.
• A broken (— — —) beep signal directly after a shot indicates that the shot
was correctly exposed. The flash is only ready however after a second (about
two seconds) continuous beep.
key to confirm the special function
Set
and
repeatedly to return the display to its nor-
is not pressed, the
Beep signals when adjusting automatic mode settings:
• A short beep signal as an alarm in automatic mode indicates that the aperture
and ISO settings exceed the permissible light control range. The auto aperture of
the mecablitz is then automatically adjusted to the next permissible value.
Setting procedure:
• Press the button repeatedly until „Select"
Sel
appears on the display.
• Use the and buttons to select „BEEP" from
the menu. The selected menu item will be highlighted
against a dark background.
• Press the key to confirm the special function
Set
selection.
• Choose the setting desired using the
and arrows.
The setting takes effect immediately.
• Press repeatedly to return the display to its nor-
mal reading. If the key not pressed, the display
will switch back to normal automatically after appro-
ximately 5 seconds.
When the beep function is turned on,
the symbol is also displayed on
the LC display.
Select
Beep
Remote
Set
ON
Set
M
MZoom 35
11 m
109