Connection D - Controller To Pump Connection - Agilent Technologies Turbo-V 300HT PCB Bedienungshandbuch

17 Technical Information
Interconnections

Connection D - Controller to pump Connection

To connect the controller to the pump, an appropriate
interconnection cable must be prepared to connect the P10 connector
of the controller with the pump connector.
The following figure shows the pump output connector configuration
where pins:
Figure 13
216/260
A-F = pump temperature sensor
B-C-D = 54 Vac 3-phase output to pump motor stator
E = ground
Controller to pump cable
Turbo-V 300HT PCB Controller User Manual / 87-900-884-01 (F)