Agilent Technologies Turbo-V 300HT PCB Bedienungshandbuch Seite 240

17 Technical Information
Use
where: XXXXXX = means the word FRONT or REMOTE depending on
the last selection. The controller is factory-set for FRONT panel
operation.
F
S
Figure 23
240/260
Choose the desired selection by pressing the CYCLE pushbutton.
R O N T
E L E C
Confirm the selection by pressing the PUMP CURRENT
pushbutton.
In this way you enter into an operating phase named "Monitor
Relay Programming" described in the following paragraph.
Turbo-V 300HT PCB Controller User Manual / 87-900-884-01 (F)
/ R E M O
T I O N :
T E
F R O N T