Agilent Technologies Turbo-V 300HT PCB Bedienungshandbuch Seite 245

•
Figure 30
D
Turbo-V 300HT PCB Controller User Manual / 87-900-884-01 (F)
Press the PUMP CURRENT pushbutton to enter the data.
The run up time is factory-set to: 00h 08m 00s.
When the last digit is entered, the display shows:
E L A Y
T H R E
where: XXX = YES or NO.
Press the CYCLE NUMBER pushbutton and select YES if relay R2
must operate only after the run-up time or select NO when the R2
operation is needed right from start of the turbopump and after
the rotational speed of the turbopump exceeds for the first time
the speed threshold value (see the preceeding cycle diagram).
This function is factory-set to YES.
E V E N
S H O L D
Technical Information
Use
A F T
: X X
245/260
17
E R
X