Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Drill Bit Changing
Attention!
Before any work on the tool, disconnect the plug from
the mains!
When you use or sharpen the machine, it might heat up
enormously. You could burn your hands or get cut or
ripped by the segments. Therefore, always use
protective gloves when changing the drill bit.
The drill spindle has a right-hand thread.
To hold on spindle use an jaw wrench SW 32.
Never remove the drill bit with impacts because this way the machine will
be damaged.
With some waterproof grease which is put on the drill bit thread you can
remove the drill bit easier.
It is also a good help for easy removing to put a copper ring between the
spindle and the drill bit.
Switching on and off
Switching-on:
Press on/off switch. LED in the switch goes on.
Switching-off:
Press on/off switch again. LED goes out.
Setting
Speed (rpm)
Drill Bit Ø/mm
The speeds recommended for the different drill bits are recommended
values and can deviate dependent on material.
The machine is equipped with an adjusting wheel in
order to allow a stepless speed control from 250 to
1000 rpm.
Permanent use with low speed could cause an
earlier switch-off, because the motor then gets less
cooling air and therefore heats up faster.
(see chapter Tool Protection)
1
2
250
330
93-122
69-92
3
4
400
600
50-68
35-49
18
5
6
700
1000
30-34
22-29
Werbung
