Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Safety Instructions
Safe work with the machine is only possible if you read
this operating instruction and follow the instructions
contained strictly.
Additionally, the general safety instructions of the leaflet
supplied with the tool must be observed. Prior to the first
use, the user should absolve a practical training.
If the connection cable gets damaged or cut during the
use, do not touch it, but instantly pull the plug out of the
socket. Never use the tool with a damaged connection
cable.
Do not work near materials which are explosive or easily inflammable.
Do not work with materials containing asbestos.
Modifications on the tool are prohibited.
Always check the tool, cable and plug before use. Have damages only
repaired by specialists. Only insert the plug into the socket when the
machine is switched off.
The machine should only work under supervision of somebody. Pull
the plug and switch the machine off if it is not under supervision, e.g. in
case of putting up and stripping down the machine, in case of setting
up and striking, voltage drop or when fixing or mounting an accessory.
Switch the machine off if it stops for whatever reason. This way, you
avoid that it starts suddenly and not under supervision.
Do not use the tool if one part of the housing is damaged or in case of
damages on the switch, cable or plug.
Before use, make sure that the tool is correctly fixed and fastened. Let
it run for about 30 seconds in a safe position. If considerable vibrations
occur or if other defects are recognised, switch off immediately.
While working, lead the line cord / extension cord or the extraction hose
to the back away from the tool.
When using the machine, no cooling water is allowed to get into
the motor and the electric mounting parts, no matter in which
position you work.
Power tools have to be inspected by a specialist in regular intervals.
Never carry the tool at its cable.
Do not touch rotating parts.
Persons under 16 years of age are not allowed to use the tool.
When working with the tool, wear protective gloves, ear protectors and
goggles.
For further safety instructions, please refer to the enclosure!
15
Werbung
