Hitachi SET FREE-Serie Bedienungsanleitung Seite 18

TRANSPORT, LIFTING AND HANDLING OF THE UNITS
5.2 HanDlinG
When using forklift, do not insert forks into the holes on the unit
side. The unit may be damaged.
Holes on the
unit side
Forks
5.3 liftinG metHoD
Do not remove any of the protective packaging from the unit to
protect it during handling and lifting.
The unit should only be lifted from the base.
Fit the hoisting slings through the openings on the base of the
unit.
!
D a n G e r
• Always use textile slings in good condition, without cuts or
wear, and with the correct capacity for lifting the outdoor unit.
• Do not fit the slings on the wooden base of the unit. The wooden
base is only designed to protect the base of the unit during
transportation; it will not withstand the strain of lifting the unit.
• Do not use metal cables to lift the unit. Metal cables may slip
and could cause the unit to tilt or fall during the lifting operation.
Sling belt
position
Sling belt
Long hole
Sling belt
Long hole
8 PMML0479 rev.2 - 02/2018
Corrugated paper frame
CORRECT
Do not remove
corrugated paper frame
Do not apply any force to
INCORRECT
surface (both sides)
!
C a U t i o n
National and local legislation must be observed with respect to driving
and the handling of loads with fork-lift trucks.
Do not apply excessive force to the square holes with forks or
other materials. The bottom of the unit may be deformed.
• Do not push the bottom base by a fork.
• Do not use a roller.
Do not apply an excessive force.
Slightly tighten the two hoisting slings.
Insert protection between where the slings touch the upper
protective cardboard packaging of the the unit. The slings must
not touch the unit.
The slings should form an angle of more than 60° with the upper
part of the unit. The unit should be kept horizontal throughout
the lifting operation. If necessary, tie guide ropes on to prevent
the unit from swinging freely during the lifting process.
!
D a n G e r
No-one should remain in the radius of action of the crane during the
lifting process.
Sling belt
Apply sling belt through
(Both sides)
Min. 2.0 m
Angle of sling belt is
more than 60º.
Apply sling belt on the splints
or corrugated cardboard pads
more than 15 mm thickness.
the long hole.