Scheppach CSE2700 Originalbetriebsanleitung Seite 41

- Points of sale of electrical appliances (stationary
and online), provided that dealers are obliged to
take them back or offer to do so voluntarily.
- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.
- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
• If the manufacturer delivers a new electrical appli-
ance to a private household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer's customer service for
this.
16. Troubleshooting
Fault Possible cause
No electricity
Motor does not run
Chain brake
Running out of carbon brush
Chain does not move Chain brake
Blunt chain
Poor cutting perfor-
Chain tension
mance
Check that the chain is fitted correctly
Saw works only with
difficulty Chain jumps Chain tension
off sword
Chain becomes hot Chain lubrication
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal
of waste electrical and electronic equipment.
You can find out how to dispose of the disused
device from your local authority or city adminis-
tration.
Fuels and oils
• Before disposing of the unit, the fuel tank and the
engine oil tank must be emptied!
• Fuel and engine oil do not belong in household
waste or drains, but must be collected or disposed
of separately!
• Empty oil and fuel tanks must be disposed of in
an environmentally friendly manner.
Remedy
Check socket, cable and plug.
Damaged cable: Have repaired by Customer Ser-
vice. It is prohibited to patch the cable with insulating
tape. Damaged switches have to be replaced by a
Customer Service workshop
See section "chain brake" and "Releasing the chain
brake"
Change the carbon brush, ask a Customer Service
workshop
Check the chain brake, release if necessary.
Sharpen the chain
Chain wrongly fitted
Check the chain tension
Check the chain tension
Check oil level
Check Chain lubrication
www.scheppach.com
GB | 41