Hilti HIK-T 12 Bedienungsanleitung Seite 4

Page 3 of 30 of European Technical Assessment ETA-22/0275, issued 2022-11-07
II SPECIFIC PART OF THE
EUROPEAN TECHNICAL
ASSESSMENT
1 Technical description of product
Technical description of the product
HILTI HIK-T 12 and HILTI HIK-T 16 are post-
installed anchor systems placed into predrilled
holes in concrete, in masonry and anchored by
bonding.
HILTI HIK-T 12 or HILTI HIK-T 16 distance fixing
systems consist of a M12 or M16 threaded rod
made from carbon steel or stainless steel and a
thermal separation module made from polyamide.
The fixing system is placed into a pre-drilled hole
perpendicular to the surface (maximum deviation
5°) in masonry or concrete, and anchored by
bonding the threaded rod element to the wall of the
drilled hole.
The product description is given in Annex A.
2 Specification of the intended use in
accordance with the applicable
European Assessment Document
(hereinafter EAD)
The intended use is fixings through an ETICS into
the loadbearing wall of heavy-duty fixtures such as
awnings, French balconies, canopies, satellite
dishes, etc.
The system is used for distance installations in the
following insulated base materials:
• Normal weight cracked or non-cracked
concrete (base material group a)
• Solid masonry bricks (base material group b)
• Perforated or hollow bricks (base material
group c)
• autoclaved aerated concrete (base material
group d)
Reference to base material group in EAD 330499-
02-0604 and EAD 330076-00-0604.
Anchorages subject to: Static or quasi-static
loads.
Temperature range:
•
T1: -40°C to +40°C (max. short term
temperature +40°C and max. long-term
temperature +24°C)
•
T2: -40 °C to +80 °C (max long term
temperature +50 °C and max short term
temperature +80 °C)
The minimum and the maximum installation
temperature are specified by the manufacturer
within the above range.
Use categories in respect of use:
• Category d/d: Use in dry masonry and
concrete Category
• w/w: Use in wet masonry only.
This ETA applies only where concrete or
masonry members in which the distance fixing
systems are embedded are subject to static or
quasi static actions in tension, pressure, shear or
combined tension and shear or pressure and
shear or bending.
In case of a product use in ETICS or insulations,
it must be ensured that no debris and remaining
of ETICS or insulations influence the load
bearing capacity in the base material.
The performances given in Section 3 are only
valid if the anchor is used in compliance with the
specifications and conditions given in Annex B1
to B5.
The provisions made in this European Technical
Assessment are based on an assumed intended
working life of the anchor of 50 years.
The indications given on the working life cannot
be interpreted as a guarantee given by the
producer or Assessment Body but are to be
regarded only as a means for choosing the right
products in relation to the expected economically
reasonable working life of the works.