Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Page 14 of 30 of European Technical Assessment ETA-22/0275, issued on 2022-11-07
Table B 2.1: Installation parameters in base material (see drawing in Annex A2)
Anchor type
Insulation thickness incl. insulation
plaster
Min. thickness of member
Effective anchorage depth
Drill hole diameter
Depth of drill hole in the base material
Diameter of clearance hole in the
fixture for the M12 threaded pin
Diameter of clearance hole in the
fixture for the M12/M10 threaded pin
Length of threaded pin
Thickness of fixture
Installation torque to fix the fixture*
For hollow base material a perforated sleeves must be used for the anchor adhesive, in accordance
with ETA of anchor adhesive.
T
= 19 Nm resp. 25 Nm are valid for the thermal separation module. Max. T
*
inst
anchor adhesive must also be observed.
a)
as delivered with threaded pin M12 or with reduction threaded pin M12/M10
b)
with any longer threaded rod, washer and nut which complies to the specifications given in table A
5.1 position 3 and 3a. The introduction of bending moment is not allowed. Constructive measures
must be applied to exclude any bending moment.
HIK-T 12, HIK-T 16
Intended use
Installation parameters
HIK-T 12
h
[mm]
60 - 220
D
h
[mm]
min
≥
h
[mm]
ef
in accordance with anchor adhesive
d
[mm]
0
≥
h
[mm]
1
≥
d
[mm]
f
≥
d
[mm]
f
≥
L
[mm]
p
t
[mm]
fix
≤ [Nm]
T
inst
HIK-T 16
60 - 300
ETA
13
11
50
0 – 24
a)
b)
max. 200
19
25
given in ETAs of
inst
Annex B4
Werbung
