Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Page 16 of 30 of European Technical Assessment ETA-22/0275, issued on 2022-11-07
HIK-T 12, HIK-T 16: Installation instruction (in concrete or solid masonry)
HIK-T 12, HIK-T 16
Intended use
Installation instruction in solid base materials
Inject the adhesive starting at the back of the hole,
slowly withdrawing the mixer! Fill approximately 2/3
of the drill hole!
Use an electric screwdriver and a hexagonal drive
of size SW6 to screw-in the anchor system! Drive it
carefully and not too fast to ensure proper seat of
the plastic collar with sealing ring!
After curing time in accordance with information
given in the Instruction for Use of the anchor
adhesive, the exterior rod of the anchor system may
be adjusted by turning it out maximum two turns.
Attach the fixture and fasten it with the washer and
the nut! Apply the torque in accordance with the
information given in table B2.1 and in the
Instructions for Use of anchor adhesive! The lower
value is applicable.
Annex B6
Werbung
