Hilti HIK-T 12 Bedienungsanleitung Seite 20

Page 19 of 30 of European Technical Assessment ETA-22/0275, issued on 2022-11-07
Table B9.1 Conditions for proper installation and additional advice for installation
Note: Driving rain resistance must be designed in accordance with the provisions given in annex B2
for fasteners with an interior part made of galvanized steel.
≤8 mm
rendering
thickness
ETICS
rendered
with
plaster
>8 mm
rendering
thickness
* External Thermal Insulations Composite Systems (ETICS) or rendered insulation with reinforced plaster which are glued
only or glued and mechanically fixed.
** ≥ 5 kPa is a guideline value that the thermal separation module can apply sufficient pre-tensioning force in the insulation
panel to ensure the compression of the sealing ring.
•
The values stated are to be understood as guideline values in order to give the user the highest possible application safety
HIK-T 12, HIK-T 16
Intended use
Conditions for proper installation and additional advice for installation
HIK-T 12, HIK-T 16
ETICS* with insulation panels made of
XPS Mineral wool,
EPS compression
strength ≥ 5 kPa**
Standard installation in accordance with annex B5, B6,
B7 and B8
Drill the hole through the insulation and in the base
material with a regular drill bit. Afterwards, enlarge
the hole in the plaster to d=26 mm by using e.g., a
wood drill bit.
wood fiber, raw wood fiber, raw
density density >230kg/m
≤230kg/m
3
and or compression
compression
strength
≤ 100 kPa
Drill the hole
through the
insulation and in the
base material with a
regular drill bit.
Afterwards, enlarge
the hole in the
plaster and
insulation to
diameter 26 mm to a
depth of 60 mm. For
this purpose a wood
drill bit may be
used.
Annex B9
3
strength
> 100 kPa