Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Page 17 of 30 of European Technical Assessment ETA-22/0275, issued on 2022-11-07
HIK-T 12, HIK-T 16: Installation instruction (in hollow masonry)
HIK-T 12, HIK-T 16
Intended use
Installation instruction in hollow masonry
Important dimension for proper installation
h
...minimum bore hole depth, h
0
embedment depth, e...insulation thickness including
tolerance layer and rendering
h
=e+h
0
ef
Switch the drill to rotary mode (no hammer action)!
Drill a hole through plaster, insulation and tolerance
layer until the drill bit touches the base material!
Consider a plus tolerance of 15mm to h
required drilling depth on the drill bit accordingly!
Switch the drill to rotary mode (no hammer action)
respectively remain in rotary mode!
Drill a hole to the required drilling depth indicated by
the mark!
Clean the borehole two times with compressed air!
Withdraw the nozzle while blowing.
Brush the borehole two times using the HILTI brush
tailored to the borehole diameter!
Clean the borehole two times with compressed air!
Withdraw the nozzle while blowing.
Mark the length h
!
0
Cut the anchor system to length h
Discard the superfluous plug if plugging together
sieve sleeve to cover the required embedment
depth!
Plug in the plug if sieve sleeve is used solitarily.
...effective
ef
and mark
0
!
0
Annex B7
Werbung
