Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TROUBLE SHOOTING
Nothing happens when I try to vacuum package
1.
Check power cord to see if it is firmly plugged into electrical outlet.
2. Check switch to see if it's setting is "o".
3.
Examine power cord for any damages.
4.
See if electrical outlet is operative by plugging in another appliance.
5. Twist the Fuse Cap off, then look at the clear tube to see if the Fuse is
darkened. If the Fuse is darkened, it will need to be replaced with a
standard 10-amp Buss Fuse.
6.
If your appliance has a mode switch, make sure it is set to the correct
mode. Refer to the above operating instructions
7.
Make sure bag is placed correctly inside Vacuum chamber and beneath
the air intake.
Air is not removed from the bag completely:
1.
To seal properly, open end of bag should be resting entirely inside
vacuum chamber area.
2.
Check sealing strip and the foam gasket beneath the lid for debris and
position. Make sure no breaking or distortion of the foam seal gaskets on
both the cover and on the base around the vacuum chamber. Wipe clean
and smooth them back into place.
3.
Vacuum bag may have a leak. To test, seal the bag with some air in it,
submerge in water, and apply pressure. Bubbles indicate a leak. Reseal
or use another bag.
4.
Uses only the specific vacuum bag with vacuum channels provided by
the manufacturer.
5.
Leaks along the seal which can be caused by wrinkles, debris crumbs,
grease or liquids. Reopen bag, wipe the top inside of the bag and
smooth it out along the sealing strip before resealing.
The machine does not turn to seal after vacuuming:
1.
There is a vacuum pressure sensor built in this machine. The machine
will not turn to seal automatically if the vacuum pressure inside the bag
is not able to reach to the predetermined vacuum pressure. Check
- 22 -
Werbung
