Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.
Do remember to make sure the lid of appliance is unlocked when
not in use and in storage. Keep the cover locked will distort the
foam gaskets causing leaking.
MAINTENANCE KIT INSTRUCTIONS
Replacing the gasket:
1. Turn " O" the switch and remove the Power Cord from the electrical outlet.
2. Make sure the unit is completely cool.
3. Open the Acrylic Vacuum Lid.
4. Remove the gasket from the groove on the underside of the Acrylic
Vacuum Lid.
5. Remove the gasket from the groove in the Plastic Vacuum Chamber.
6. Set a new gasket on the groove in the Plastic Vacuum Chamber. Work the
seal into the groove with your fingers until done.
7. Position a new gasket into the groove in the Acrylic Vacuum Lid. Work the
seal into the groove with your fingers until done.
Replacing the Teflon tape:
1. Turn "O" the switch and remove the Power Cord from the electrical outlet.
2. Make sure the unit is completely cool.
3. Open the Acrylic Vacuum Lid.
4. Pick at either end of the Teflon Tape covering the Seal Bar Heating
Element with a fingernail or sharp-edged tool until it lifts slightly. Grasp the
loose end and slowly pull the Teflon Tape back over itself until fully removed.
6. Remove the backing from a new wide strip of Teflon Tape for the Seal Bar
Heating Element. Be careful not to allow the Teflon Tape to contact anything
including itself while the adhesive side is exposed.
7. Hold one end of the Teflon Tape in each hand. Stick the left end of the
Teflon Tape to the flat area on the Plastic Vacuum Chamber just left of the
Seal Bar Heating Element. Apply the Teflon Tape from left to right over the
Seal Bar Heating Element until done. Make sure there are no wrinkles or
folds in the Teflon Tape once applied. The Teflon Tape should fully cover the
Seal Bar Heating Element.
- 21 -
Werbung
