Herunterladen Diese Seite drucken

Parkside PPTLBA 40-Li A1 Originalbetriebsanleitung Seite 33

Akku-turbinenlaubbläser 40 v

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
1. Press and hold the on/off switch (11) to
start the device.
2. In order to regulate the blowing power,
press the volume control (9).
Pressing
Pressing
The 4 LEDs below the charge level indi-
cator (8) on the control panel indicate
the level of the blowing power.
3. To switch off, briefly press the on/off
switch (11).
Turbo mode
1. Press and hold the TURBO button (10)
to turn the blowing power to turbo
power for a maximum of 15 seconds.
Turbo mode stops automatically after
15 seconds but can be started back
up by pressing the TURBO button (10)
again.
2. Release the TURBO button to exit turbo
mode.
Checking the charge status
of the battery
The charge level indicator (8) shows the
state of charge of the battery (2) as long
as the device is turned on via the On/off
switch (11) on the control panel.
The charge level of the battery is indicated
by illumination of the corresponding LED
lights.
3 LEDs illuminated (red, orange and
green): Battery charged
2 LEDs illuminated (red and orange):
Battery partially charged
= one level higher
= one level lower
1 LED illuminated (red):
Battery needs to be charged
Working with the leaf blower
The leaf blower may only be
used for the following pur-
poses:
- As a blower to pile up dry
leaf material or to blow mate-
rial out of places that are hard
to access (e.g. under cars).
During work, ensure that the device
is not struck against hard objects,
which can cause damage.
Blowing operating mode:
• You get optimal results when you use
the blower with a separation distance
to the ground of 5 -10 cm.
• Begin work with the highest blowing
power, in order to rapidly pile up the
leaves lying around. Select a lower
blowing power to compact the previ-
ously piled up leaves.
• Before blowing, loosen leaves adhering
to the ground with a broom or rake.
• The guide rollers at the end of the tube
make it easier to work on flat surfaces.
• Hold the device by the handle (1) when
working.
Working with the blower pipe
and attachment/flat nozzle: With
the blower pipe and attachment, you
can collect leaves over a wider area.
The flat nozzle functions as a turbo
nozzle, which can be used to reach the
highest air speed.
GB
MT
33

Werbung

loading